If I set LightBurn to Current Position and then set the Job Origin to anything but the lower left corner, the machine frames in the wrong place. It always frames as if it were starting from Current Position but with the Job Origin in the lower left corner. I’m using a 22W Creality Falcon 2. I’m using G-Code files instead of a USB connection. Below is a picture of a scrap piece of cardboard I was running tests on to figure out alignment. You can see my pencil marked X, whcih I was trying to hit
Creality Falcon 10w strange draw - LightBurn Bridge - LightBurn Software Forum
Limited Time Offer
Solved - Creality Falcon 2 Win 7 cannot connect - LightBurn Hardware Compatibility - LightBurn Software Forum
Xtool d1 10w ra2 rotary center point - LightBurn Hardware Compatibility - LightBurn Software Forum
【Entry Level Engraver】5W is the engraver laser output power, which figures measure the capability of the machine to cut and 40W is the machine power
Creality Laser Engraver, 5W Laser Cutter Engraving Machine for Personalized Gifts,40W High Accuracy DIY Laser Engraving Machine,CNC Machine and Laser
Creality Falcon (or Lightburn?) issue. : r/LightBurn
Laser engraver - Creality CR-Laser Falcon 10W - Luxury Package Botland - Robotic Shop
HOW TO FIX CREALITY FALCON 2 ENGRAVER OR LIGHTBURN NOT CONNECTING TO COMPUTER– SOLVED! –
Creality Falcon 10W - Distorted chapes (e.g. uneven circles) - LightBurn Hardware Compatibility - LightBurn Software Forum
Creality Falcon (or Lightburn?) issue. : r/LightBurn